AFS Outworld – M v3

Description

Contents of pack:

• 2 x Perspex side panels (one with logo)
• 2 x Perspex side panels with hole and screw holes each side of the port
• 1 x Perspex top panel: consisting of 3 pieces 
• 1 x Coloured base panel

• 33 x 8mm screws 
• 4 x nuts

• 4 x Block A
• 4 x Block B

• 2x Port slope + magnet connector 
• 1x blank to seal off the port if needed
• 4 x Feet 
• 1 x Handle 
• 1 x Allen key 

Assembly instructions: 

1. Remove protective film from perspex sheets. 
2. Attach blocks A and B to the base in the positions shown overleaf with 8mm screws. Make sure to keep the rough side of each block facing down onto the base. This will help with orientation. Note: The pre-separation of blocks A and B will help as they alternate in each corner – see image below. 
3. Before screwing the sides onto the base. Attach the slope and magnet connector to the perspex side panel with two screw holes each side of the port.
4. Attach side panels with screws ensuring side panels with holes are on opposing sides, and keeping the logo facing outwards. Make sure to put the slope on the inside of the nest and the magnets on the outside. 
5. Attach blocks A and B to the top corners in positions shown below. Make sure to keep the rough side of each block facing up. This will help with orientation.
6. Attach the top panel and assemble the lid using screws and nuts, this can be tightened by hand. Then the handle, using a single screw from the underside of the lid into the handle. See image below.
7. Lastly, make sure that each screw is tight, then attach the feet to the bottom 4 screws by pushing them on by hand.